diff --git a/Devices/Console/Firmware/platformio.ini b/Devices/Console/Firmware/platformio.ini
index 9e49227..6689a4d 100644
--- a/Devices/Console/Firmware/platformio.ini
+++ b/Devices/Console/Firmware/platformio.ini
@@ -1,16 +1,68 @@
-; PlatformIO Project Configuration File
-;
-;   Build options: build flags, source filter
-;   Upload options: custom upload port, speed and extra flags
-;   Library options: dependencies, extra library storages
-;   Advanced options: extra scripting
-;
-; Please visit documentation for the other options and examples
-; https://docs.platformio.org/page/projectconf.html
+[platformio]
+default_envs = Upload_UART ; Default build target
 
-[env:console]
+
+; Common settings for all environments
+[env]
 platform = atmelavr
-board = nanoatmega328
 framework = arduino
+
+; TARGET SETTINGS
+; Chip in use
+board = ATmega328P
+; Clock frequency in [Hz]
+board_build.f_cpu = 16000000L
+
+; BUILD OPTIONS
+; Comment out to enable LTO (this line unflags it)
+build_unflags = -flto
+; Extra build flags
+build_flags = 
+
+; SERIAL MONITOR OPTIONS
+; Serial monitor port defined in the Upload_UART environment
+monitor_port = ${env:Upload_UART.upload_port}
+; Serial monitor baud rate
+monitor_speed = 9600
+
+
+; Run the following command to upload with this environment
+; pio run -e Upload_UART -t upload
+[env:Upload_UART]
+;  Serial bootloader protocol
+upload_protocol = arduino
+; Serial upload port
 upload_port = COM4
-monitor_port = COM4
+; Get upload baud rate defined in the fuses_bootloader environment
+board_upload.speed = ${env:fuses_bootloader.board_bootloader.speed}
+
+
+; Run the following command to upload with this environment
+; pio run -e Upload_ISP -t upload
+[env:Upload_ISP]
+; Custom upload procedure
+upload_protocol = custom
+; Avrdude upload flags
+upload_flags =
+  -C$PROJECT_PACKAGES_DIR/tool-avrdude/avrdude.conf
+  -p$BOARD_MCU
+  -PUSB
+  -cusbasp
+; Avrdude upload command
+upload_command = avrdude $UPLOAD_FLAGS -U flash:w:$SOURCE:i
+
+
+; Run the following command to set fuses
+; pio run -e fuses_bootloader -t fuses
+; Run the following command to set fuses + burn bootloader
+; pio run -e fuses_bootloader -t bootloader
+[env:fuses_bootloader]
+board_hardware.oscillator = external ; Oscillator type
+board_hardware.uart = uart0          ; Set UART to use for serial upload
+board_bootloader.speed = 115200      ; Set bootloader baud rate
+board_hardware.bod = 2.7v            ; Set brown-out detection
+board_hardware.eesave = yes          ; Preserve EEPROM when uploading using programmer
+upload_protocol = usbasp             ; Use the USBasp as programmer
+upload_flags =                       ; Select USB as upload port and divide the SPI clock by 8
+  -PUSB
+  -B8